User Manual
Chapter 3: Installation and Wir ing
U ser 's M a n u a l 0 300 21 5- 03 R ev. A
3-5
Sec t ion 3.5
Mounting
!
Attention
During panel or DIN ra il mounting of all devices, be sure that a ll debris
(metal chips, wire strands, etc.) is kept from falling into the module.
Debris that falls int o the module could cause da mage at po wer up.
3.5.1 Minimum Spacing
Maintain spacing from enclosure walls, wireways, adjacent equipment, etc. Allow 50 mm
(2 in.) of space on all sides for adequate ventilation, as shown below:
Figure 3-3
3.5.2 Panel Mounting
Mount the module to a panel using two screws per module. Use M4 or #8 panhead
screws. Mounting screws are required on every module.