User guide

The following LED displays are used with ControlLogix analog HART

modules:

Using RSLogixUsing RSLogix

Using RSLogix

5000 to5000 to

5000 to

ouboub

oub

leshootleshoot

leshoot

our Moduleour Module

our Module

In addition to the LED display on the module, RSLogix 5000 will alert you

to fault conditions. You will be alerted in one of three ways:

· Warning signal on the main screen next to the module-This occurs when

the connection to the module is broken

· Fault message in a screen’s status line · Notification in the Tag Editor -

General module faults are also reported in the Tag Editor. Diagnostic faults

are only reported in the Tag Editor

· Status on the Module Info Page

The screens below display fault notification in RSLogix 5000.