Instruction Manual

52 SLC 500

™

Universal Analog Input Module

Procedure

1. Using the memory map function, create integer file N10. Integer file

N10 should contain eight elements (N10:0 through N10:7).

2. Using the APS software data monitor function, enter the

configuration parameters for all eight universal channels into a source

integer data file N10.

Figure 5.2 Data table for initial programming

address 15 data 0 address 15 data 0

N10:0 0000 0010 0010 0011

N10:3 0000 0010 0010 0011

N10:4 0000 0010 0010 0011

N10:5 0000 0010 0010 0011

N10:6 0000 0010 0010 0011

N10:7 0000 0010 0010 0011

Press a key or enter value

N10:3/0 = 1

offline no forces binary data decimal addr File EXMPL

CHANGE

RADIX

SPECIFY

ADDRESS

FILE

3. Program a rung in your ladder logic to copy the contents of integer

file N10 to the eight consecutive output words of the universal

module beginning with O:3.0.

Figure 5.3 Initial programming example

First Pass Bit

s:1

] [

COP

COPY FILE

Source #N10:0

Length 8

Dest #O:3.0

Initialize Module

On power up, bit S:1/15 is set for the first program scan, and integer file N10

is sent to the NI8u channel configuration words.