Owners manual

Step 15
Connect the supplied hose to
the breather tube on the motor.
© 2015 SPECTRE PERFORMANCE Made in China
[phone]
www.SpeedBySpectre.com
176149B
4/13/15
Step 16
Install the ex coupler on the
end of the MAFS and secure the
boot in place. Install a second
clamp but do not tighten at this
time.
Step 17
Install the intake tube as shown
and once in position tighten
clamps.
Step 18
Reconnect the MAFS wiring
harness.
Step 19
Install the new hose onto the
vacuum tting on the intake
tube.
Step 20
Install the lter and fully tighten
the clamp.
Step 21
Reinstall the engine cover. Make sure that
all clamps and hardware are fully tightened.
Reconnect the battery cable, start the vehicle
and let it warm up. Shut off and inspect the
installation once more for any loose clamps,
wires, or hardware. Test drive & enjoy! Your
installation is now complete. Periodically
check all clamps and brackets.
If you have any difculties or questions regarding the installation of this intake system, contact the Spectre
Performance Technical Department by email - [e-mail] or by phone [phone]
Monday thru Friday 6:00am to 2:00pm PST.