Owners manual

Step 1
Safety rst! Before you begin the installation, make sure that the vehicle is in park (or neutral for a
manual transmission) with the parking brake set. Disconnect the negative battery terminal and verify
that all components that are listed are present. Note: This kit was designed and tested on a stock en-
gine without any custom tuning done to the engine computer. Removing the battery cable may erase
the programmed radio stations. The anti-theft code will need to be entered into some radios after the
battery cable is connected. The anti-theft code can typically be found in the owner’s manual or at your
local dealership.
Step 2
Start by removing the engine cover that is attached by small ball
and socket joints or fastened with hardware. Lift the cover up and
off and it will come off easily. Depending on the year, make, and
model the cover may vary.
Step 3
Loosen the clamp at the throttle
body.
Step 4
Loosen the clamp at the Mass
Air Flow Sensor (MAFS).
Disconnect the MAFS electrical
connector.
Step 5
Pull rmly and disconnect the
breather hose from the stock
intake resonator. Remove the
factory intake tube.
Step 6
Remove the breather tube from
the engine by pulling the rubber
end rmly from the engine.
176149B
4/13/15