Owners manual

Step 9
Place the rubber vibration
mount, fender washers and
M6 lock nuts on the side of
the housing as shown. Do not
tighten the bolts at this time.
Step 10
Slide the 4” angled coupler and
two 4” hose clamps over the
throttle body. Do not tighten the
clamps at this time.
Step 11
Place the intake tube in the engine compartment. Slide the lower
angled bracket between the vibration mount and the housing.
Step 12
Insert the radiator hose bracket
into the bracket on the side of
the intake tube.
Step 13
Install the adapter ring onto the MAF as shown. Install the 4”
coupler over the adapter ring and secure with the supplied hose
clamp.
Step 14
Attach the MAF sensor and OE
rubber ring to the MAF adapter.
Slide the adapter between the
rubber ring and the tabs as
shown. Secure MAF sensor to
the adapter with the OE hose
clamp.
176153A
1/27/16