Owners manual

Step 1
Safety First! Before you begin,
disconnect the negative terminal on
your battery. Verify all components
listed are present before beginning
your installation.
Step 2
Start by loosening the clamps securing the OE intake tube to the
throttle body and the MAF sensor
Step 3
Remove the OE intake assembly
out of the engine.
Step 4
Disconnect the MAF sensor.
Step 5
Grab the air box from both sides
and pull up and out. The air
box is held in place with rubber
grommets
Step 6
Loosen the hose clamp
securing MAF sensor to the
air box. Carefully remove MAF
sensor and rubber ring from the
air box assembly and set aside
for later use.
Step 7
Remove the ve 10mm bolts
securing the lower air box tray
and remove tray. Set the bolts
aside as they will be reused
later.
Step 8
Using the included 5mm Allen bolts,
lock nuts and washers, assemble
the heat shield as shown. Install
the Allen bolts from the outside of
the shield and put the at washer
and lock nuts on the inside. Once
all the hardware is installed, use
the included hex key wrench and an
8mm (5/16” will also work) wrench
to fully tighten all of the lock nuts.
Place the lter shield in the engine
compartment. Secure the shield
with the air box tray bolts removed
in step 7.
176153A
1/27/16