User's Manual

1
Other Information
5
T800
Dimensions & Weight
Size: 185 (L) x 84 (W) x 56 (H) mm
(Without magnetic stripe card reader)
185 (L) x 88 (W) x 56 (H) mm
(With magnetic stripe card reader)
Weight: 500g (Terminal with battery)
Operating environment
Temperature: 0 C - 45 C
Humidity: 0% - 85% (non-condense)
DC 9V, 3A
Power input
185 (L) x 105 (W) x 56 (H) mm
(With SMA connector)
This device complies with part 15 of the FCC Rules. Operation is subject
to the following
to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received,
including interference that may causeundesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the
user's authority to operate the equipment.
Specific Absorption Rate (SAR) information:
This wireless phone meets the government's requirements for exposure to radio waves. The guidelines
are based on standards that were developed by independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include a substantial safety margin designed
to assure the safety of allpersons regardless of age or health.FCC RF Exposure Information and
Statement The SAR limit of USA (FCC) is 1.6W/kg averaged over one gram of tissue. Device types: T800 (FCC ID:
(FCC ID: VWZT800W) has also been tested against this SAR limit. The highest SAR value reported
under this standard during product certification for use when properly worn on the body is 1.07W/kg.
This device was tested for typical body-worn operations with the back of the handset kept 1.5cm from the
body. To maintain compliance with FCC RF exposure requirements, use accessories that
maintain a
1.5cm separation distance between the user's body and the back of the handset. The use of
belt clips
holsters and similar accessories should not contain metallic components in its assembly. The use of
accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and
and should be avoided.
Body-worn Operation
Note: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct
the interference at his own expense.