T800 EFT-POS Installation Guide Version 1.
T800 Table of Content 1. Layout & Function Descriptions of T800....................................... 2 1.1 Main Unit & Accessories............................................................................................ 2 1.2 Features at a Glance................................................................................................. 3 1.3 Installation of SIM, SAM & Micro-SD Card................................................................. 4 1.4 Battery Installation.......................
T800 1 Layout & Function Descriptions of T800 1.1 Main Unit & Accessories Terminal - for transaction processing, PIN entry, printing, communication and other peripheral interfaces such as ECR integration 7.
T800 1.
T800 1.3 Installation of SIM, SAM & Micro-SD Card SAM Card Micro-SD Card 1 2 SIM Card SAM Card and Micro-SD Card - for version equipped with Micro-SD card reader only 1.
T800 1.5 Paper Feeding Procedure 1 Place the paper roll into the tray as shown Press the button to open the paper cover 2 3 Close the paper cover 40mm Max.
T800 1.
T800 2 How to Operate 2.1 Turn On/ Off Procedure If the terminal is equipped with charging battery during first time use, please connect the power adaptor and charge the battery for 3 hours. On - Power is on whenever plugged. If the terminal is unplugged, press the key for several seconds to turn on the terminal. When the terminal displays "PLEASE SWIPE CARD", it is ready for operation. Off - Disconnect the power adaptor. Keep on pressing the key for several seconds to turn off the terminal. 2.
T800 3 Rechargeable Battery Safety Guideline 3.
T800 3.3 Terminal and Battery Storage Guideline If the battery will not be used for a long period, please charge it to only 50% of the battery capacity (battery indicator displays half full, 2 units); remove it from the terminal and store in a cool place. This can minimize the life deterioration caused by self-discharge DO NOT store bare battery together with metal, avoid humid and hot storage During storage period, please recharge the battery once every 3 months 3.
T800 4 Safety & Maintenance 4.1 Basic Safety Practice While using terminal and its accessories, please follow the safety instruction to avoid fire, electric shock and personal injury.
T800 4.3 Location for Installation Should be safe and convenient for operators and users Should be placed on stable working platform during desktop operation for ease of power and accessories connection Good ventilation and should have 10cm space around the terminal DO NOT expose terminal in following environment ~ Near electrical appliance with high frequency EM wave such as air conditioner, electric fan, motor, neon sign etc. ~ Liquid container such as water trough, sink, pond etc.
T800 Printer Cleaning Disconnect power cable from the terminal Open paper cover, take out paper and roller Remove dust and paper scrap inside paper tray . Use low pressure blower to clean the paper tray if possible.
T800 Malfunction on printer 1, If the terminal is powered by battery, check the battery level and charge the battery, replace new battery or else power the terminal by adaptor. 2, If it is powered by power adaptor, check whether the connection of power cord or power adaptor is connected properly 3, Open paper cover, check whether the paper is used up 4, Check whether the way of paper feeding is correct, please refer to section 1.
to the following 5 T800 Other Information Dimensions & Weight Size: 185 (L) x 84 (W) x 56 (H) mm (Without magnetic stripe card reader) 185 (L) x 88 (W) x 56 (H) mm (With magnetic stripe card reader) 185 (L) x 105 (W) x 56 (H) mm (With SMA connector) Weight: 500g (Terminal with battery) Operating environment Temperature: 0 C - 45 C Humidity: 0% - 85% (non-condense) Power input DC 9V, 3A This device complies with part 15 of the FCC Rules.
requirements may not comply with RF exposure requirements and should be avoide
