Product Manual

9
PressandreleasetheMENUbuttonattheStandardDisplay.
Pressing and releasing button 3 changes the unit always back to the standard or previous display.
Press and release the buttons 5 to 8 until the desired icon is highlighted.
Press and release button 4toopenthesubmenuORstarttheselectedfunction.
Note: Pairing function is needed to pair an already paired remote with a new transmitter.
The new transmitter has to be set to the pairing dialog for this operation. Otherwise the pairing can not be
successful processed.
The pairing information of the previous pairing is still stored in the previous paired transmitter and should be
deleted in the pairing dialog of this transmitter
Note:Ifa remote ispaired withatransmitter theIRsignals oftheremote (incaseof aninterruptedradio
connection) will transmitted in a private mode so that only the paired transmitter can received these IR
commands.
6.3 Automatic PlaneLok Mode
The PlaneLok mode can be activated in horizontal and vertical
automatic and manual mode.
InPlaneLokmodewhensetuphorizontal,thebeamwillbelocked
toaxedelevationpoint(upto150m(490ft)locatedononeaxis
at each side of the laser.
Forkeepingverticalalignmentsxedtoadirectionpoint,PlaneLok
canbeusedinbothdirectionsontheY-axisand/orontheX-axis.
Note:IneveryPlaneLokmodethelasercontinuestoservotothe
receiver’ssignals.Anylossofsignaloveranextendedperiodoftime(1minute)causesthelasertogointo
theHI-alertcondition(beamturnsoff,rotorstopsandawarningmessageoccursattheLCD.PlaneLokmode
canbereactivatedaftertheerrormessagehasbeendeletedwithbutton4.ExitingofPlaneLokmodecanbe
donebypressingbutton3(ESC)oranyHL760button.
HorizontalSetUp:
1. Set up the laser over the reference point.
2.AttachtheHL760receivertoagraderod.PlacethereceiveratthesecondpointandadjustittotheOn-
grade position. The receiver should be permanently mounted at this location and at the desired elevation.
3.Usethesightingguidesonthetopofthelasertoalignthelasertothereceiver.Turnthelaseronthetripod
untilitisroughlyalignedtothereceiver’sposition(thealignmentrangeforbothaxesis+/-40°).
4.PressandreleasetheMENUbuttonattheStandardDisplayandselectPlaneLok(Pic14).
Pic 14 PlaneLok
horizontal
Pic15PlaneLok
vertical
5.Whensetuphorizontally,pressandreleasebutton4toopenthePlaneLoksubmenu;selectthedesired
PlaneLokaxisY(Pic16)orX(Pic17)orYandX-axis(Pic18)thenpressbutton4 to start PlaneLok.
Pic16PlaneLok
Y-Axis
Pic17PlaneLok
X-Axis
Pic18PlaneLokY-
andX-Axis