Instruction Manual

Description: The description given to the next stored point.

HR: The length of the rod.

: Opens the Smart Target options.

Number of Sets: The desired number of sets required when shooting each foresight. You must select at least one set.

[Traverse]: Prompts you to shoot the Foresight point. After each set is performed, the Move To Other End

dialog box

will open and prompt you to set up on the new point and enter a new instrument and rod height. The Traverse Wizard

screen will then open to guide you through the setup on the forward point.

[BS Setup…]: Opens the Station Setup

screen where the current backsight can be modified.

: A shortcut to the Surveying Settings and Repetition Settings screens.

Record Mode

[Survey] [Record Mode]

When running in Record Mode, all control of the total station is performed from the total station's keypad. The data

collector will simply log each shot that is taken from the total station.

This routine is typically used for topo work, where the total station remains over a single occupy point during all shots.

Note: Not all total stations support record mode.

Foresight: The point name that will be used when storing the next point. Once a point is stored, it will be incremented

to the next available point.

Description: The description for all the shots that are stored.

HR: The length of the rod.

: Opens the Smart Target options.

Start Recording]: Starts recording all shots performed from the total station.

[Stop]: Stops record mode.

[Backsight…]: Opens the Station Setup

screen. where the current backsight can be modified.

: A shortcut to the Surveying Settings screen.

Remote Elevation

[Survey] [Remote Elevation]

The Remote Elevation

screen will compute the elevation for the occupy point by shooting a foresight with a known

elevation, or it will compute the elevation for a foresight when the occupy elevation is known.

Survey Pro Help 5.00