Instruction Manual
Height of Rod: is the rod height.
[Backsight…]: opens the Station Setup screen where you can set your backsight.
[< Back]: returns to the previous screen
.
[Solve >]: opens the next Station Staking
screen.
Station Staking – Screen 3
[Stakeout] [Station Staking] [Next >] [Solve >]
The third Station Staking
screen shows the direction and distance information from the instrument to the selected stake
point.
The Station, Surface, and Offset information is displayed at the top of the screen.
From Instrument to Design Point: lists the direction and distance information used to aim the total station toward the
stake point.
[Circle Zero]: is used to modify the circle on the total station so that the angle right reading will be zero when it is
facing toward the design point, which can sometimes be easier than turning to an obscure angle value. When this
button is tapped, the following actions will occur:
1. A new backsight circle value is computed, sent to the instrument and stored in the raw data
2. The Angle Right value is changed to zero to reflect the change. The instrument now needs to be turned
horizontally to zero to face the design point.
3. To prevent errors, the backsight set up is invalidated when exiting the Stakeout
dialog if this button has been
used. A circle zeroed on a design point is meaningless once the design point has been staked.
4. The first time Circle Zero is used during a stakeout session, a dialog will appear to warn that the original
backsight reference will be lost.
Note: The [Circle Zero] button is not available when using a robotic total station.
[< Back]: returns to the previous screen
.
[Stake >]: opens the final Station Staking
screen used to perform the shots to stakeout the point. This is identical to
the third Stake Points
screen.
Define a Location
[Stakeout] [Define a Location]
The Define a Location
screen is used to manually enter the distance and direction to a new point from any existing
reference point and then stakeout the new point.
From Point: is the reference point that the specified angle and distance information is applied to for locating the new
point.
[Azimuth] / [Bearing]: is the direction from the reference point to the new point.
Survey Pro Help 5.00
165