Instruction Manual

Note: A motorized total station will automatically turn toward the design point after tapping [Solve>], depending on
the configuration of the Stakeout Settings screen.
Curve and Offset – Screen 3
Station: displays the current station that is being staked.
H. Offset: displays the offset distance of the curve being staked from the specified curve and if it is on the Right or
Left side of the specified curve.
Angle Right: is the horizontal angle that the total station must aim toward so that it is facing the current station.
Horz. distance: is the horizontal distance from the occupy point to the current station.
Vert Distance: is the vertical distance from the occupy point to the current station.
ZE to Rod: is the zenith angle that the total station must aim toward so that it is facing the current station.
[Circle Zero]: is used to modify the circle on the total station so that the angle right reading will be zero when it is
facing toward the design point, which can sometimes be easier than turning to an obscure angle value. When this
button is tapped, the following actions will occur:
1. A new backsight circle value is computed, sent to the instrument and stored in the raw data.
2. The Angle Right value is changed to zero to reflect the change. The instrument now needs to be turned
horizontally to zero to face the design point.
3. To prevent errors, the backsight set up is invalidated when exiting the Stakeout
dialog if this button has been
used. A circle zeroed on a design point is meaningless once the design point has been staked.
Note: The [Circle Zero] button is not available when using a robotic total station.
[< Back]: returns to the previous screen
.
[Stake >]: opens the next screen, which is identical to the third Stake Points
screen.
Click here
to view a summary of all the Stake Curve and Offset screens.
Screen Summary
Screen 1 is used to define the primary curve used to determine the location of the curve to be staked and the station
associated with the PC Point.
Screen 2
is used to define the offset distance and location, the station to be staked and the station interval.
Screen 3
provides the distance and direction information to the current station to be staked from the occupy point.
Screen 4
is used to stake the current station.
Stake Out Point (Store/Tape) Screen
Survey Pro Help 5.00
156