Instruction Manual

and stay stationary on points of interest for periods of time during the survey. Once the file is begun, the Stop and Go
Receiver Session screen opens.
Note: The location of the file is usually on the receiver’s built in memory. However, some models support collection
of post processing data to a file on the data collector. For those receivers that support it, the location of the log file is
specified on the Receiver General Settings screen.
Note: The Post Processing screen is used to start a post processing only survey. If you wish to record post processing
data simultaneous with RTK, then you should set the recording interval on the Set Base Receiver
screen and/or the Set
Rover Receiver screen when starting a RTK survey
Static Receiver Session
[Survey] [Post Processing] [Start ... >]
or [Survey] [Occupy]
The Static Receiver Session is used to enter the station name and antenna height for a static post processing
occupation. This screen opens up after you have started a static session with the Post Processing Start
screen, or if you
tap [Survey] [Occupy] and you are connected to a receiver that is already logging static data.
Point : Enter the station name for the static session.
Description: Enter the description for the static session.
Antenna: Displays antenna setup for this receiver.
[Set HR]: Opens up the Receiver Antenna
screen, where you can modify the antenna type and measurement for this
receiver
[Apply]: Sends the current station and antenna information to the receiver.
Note: Some receivers cannot change the station name and antenna height of a session once it is started, therefore, this
button may be disabled depending on your brand and model, and the state of the current post processing survey.
[End Survey]: Ends the static point occupation, and closes the file.
Start Stop/Go
[Survey] [Start Stop/Go]
When you are starting a stop and go post processing survey you will first be prompted to select a receiver with the
Connect to Post Process Receiver screen.
Stop/Go Receiver Session
[Survey] [Post Processing] [Start ... >]
or [Survey] [Occupy]
or (in GNSS mode) [Survey] [Control Points] [Post Process]
The Stop/Go Receiver Session
screen is used to mark the beginning and end of static segments during the stop and go
post processing log file. You can enter the point name and descriptions of the static segments, as well as change the
antenna height for occupations. This screen is also used in GNSS mode if you want to record an extra occupation to
log file when logging post processing simultaneous with RTK.
Survey Pro Help 5.00
133