Manual

Start Survey at Rover
[Survey] [Start Survey]
When you are starting a survey at the RTK rover, either because the RTK base is already set, or because you are using
an NTRIP network for base corrections, select the Start Survey menu item. You will first be prompted to select a
receiver with the Connect to Rover screen.
Connect to Rover
The Connect to Rover screen is used to select a rover receiver to connect to, and to pick the format for base
corrections. The display of the receivers to select list is identical to the Receiver Settings screen. Below the list of
receivers, the modem type of the selected receiver is displayed.
Correction Format: Select the correction format of the base receiver broadcast. The formats available will depend on
your brand and model.
Note: If you have already set the correction format, either by setting the base with this instance of the Start Survey
workflow, or if you are reconnecting to the rover to resume a survey, then the Correction Format field displays the
format currently in use.
[Connect>]: Connects to the selected receiver and advanced to the Set Rover Receiver screen.
Note: If you have not already selected your projection mode, you will be prompted to do so with the Projection
Prompt before the Set Rover Receiver screen opens.
Set Rover Receiver
The Set Rover Receiver screen is used to enter the rover receiver antenna and setup the rover receiver hardware.
Rover Receiver: Displays information about the status of the receiver.
Antenna Type: Select the antenna type to use.
[Setup]: Tap to change the antenna for the base receiver. See Receiver Antenna.
Measure To: Specify the location on the antenna or receiver where the antenna height should be measured to.
Measured: Enter the distance from the ground to the Measured To location.
Post Processing Recording Interval: Sets the period for logging GPS raw data for RTK + post processing. Set it to
Off to disable post processing data collection.
[Next >]: Tap to advance to the Select Base Point at Rover screen.
Select Base Point At Rover
The Select Base Point at Rover screen is used to choose the point in the job file where the base is located, or to store a
new point for the base receiver setup location. This screen is similar to the Select Base Point screen described in the
Start Survey at Base section.
Base Antenna: Displays information about the base antenna received at the rover from the broadcast stream.
108