Reference Manual Owner manual

Survey Pro Reference Manual
R-78
Raw Data Note
Enter any note to append to the raw data file. You can
use the buttons to insert common linework commands.
When finished, tap Write Now! to append the note to the
end of the raw data file.
View DTM
Job View DTM.
Before viewing a DTM, the Setup DTM 3D screen will open where the
DTM layers must be defined. This screen is also used to define other
parameters for the DTM.
Layers : opens the Layers for Staking DTM screen
where the DTM layers are selected.
Boundary : opens the Choose Polyline screen where a
polyline can be selected that defines the boundary of the
DTM.
Exclude points…: will move any points that exist
outside the selected boundary to the Auxiliary layer. If a
point is later stored outside the boundary, they will also
be moved to the Auxiliary layer.
Discard the boundary…: will initially move any points
that exist outside the boundary to the Auxiliary layer. If
a point is later stored outside the boundary, the selected
boundary is automatically unselected.
Clear : will unselect the selected boundary and move it to the
Auxiliary layer.