Reference Manual Owner manual

Miscellaneous Screens
R-435
Create Points
Job Edit Alignments
Create Points
The Create Points screen is used to store points that coincide with
specific locations on an alignment.
Alignment Nodes: When checked, will store points at
locations where a change occurs on an alignment, for
example where a straight section and a curved section
meet.
Sta. Intervals: When checked, will store a point at the
specified station interval along an alignment.
Start Point Name: is the name for the first point that
will be stored from this screen.
Description: is the description that will be given to all
the points that are stored from this screen.
Start Location: is the location for the first point, which
is the reference location used to compute the locations of
the remaining points. The default location is the POB
defined from the Edit Alignment
screen.