Reference Manual Owner manual

COGO Menu
R-363
Mid Ordinate : The distance between the curve and the chord at the
center of the curve’s length.
External : The minimum distance between the PI and the curve.
Azimuth / Bearing : defines the direction of the curve, tangent at the
PC.
Turn: defines if the curve turns to the Left or Right while viewing the
curve from the PC Point.
: appends the curve to the list.
Add to Map
Cogo Map Check Add to Map….
The Add to Map screen is used to add the existing line and curve data
to the current job as a polyline.
Description: is the name that will be assigned to the
new polyline that will be added to the project.
Location : can be used to manually enter the
coordinates for the first point of the polyline.
Point : can be used to define the starting location of the
first point of the polyline by an existing point.
Store Points: is the first point name that will be used for
the new points that are needed to add the figure to the
current job. All additional points will be incremented
from this point.
: adds the figure to the job at the specified location.
(Cancel): closes the screen without adding any new
data to the job.