Reference Manual Owner manual

Survey Pro Reference Manual
R-292
• Automatic Slope : selects the slope that is nearest to the
current rod position.
• Force CUT Slope : forces all computations to be based on a
cut slope.
• Force FILL Slope : forces all computations to be based on a
fill slope.
Topo SS… : will store the last shot taken as a side shot.
HR: is the rod height.
: opens the Smart Target options (Page R-444).
< Back : returns to the previous screen.
Store > : opens the next screen.
Slope Staking – Screen Five
The fifth screen is used to store a point for the last shot taken from
the previous screen, which should be located at the catch point.
Point Name: is the name assigned to the stored point.
Description: is the description assigned to the stored
point.
Results : This will display the following additional cut,
fill, and location information:
• Type of slope (e.g. left/right, cut/fill)
• Design and observed slope ratios (run
over rise)
• Design and actual stations
• HD and Cut/Fill to Hinge Point
• HD and Cut/Fill to Center Line
• If applicable, HD and Cut/Fill to Edge of Pavement
and Edge of Curb
• Name of segment and HD and Cut/Fill to that
segment extremity (Road Slope Stake only)