Reference Manual Owner manual

Leveling Menu
R-263
benchmark.
Backsight Point: Lists the details for the current backsight. If this is
the first observation from the current set up, most of the details will
be unknown.
Next > : opens the Take Shot screen (Page R-260) where the
required shots are performed. If the shots are taken to an existing
point, such as when shooting the closing benchmark, the Point Exists
screen, described next, will open where the loop can be closed.
Point Exists
The Point Exists screen will appear after shooting a benchmark that
is already stored in the current job and is used to overwrite the point,
create a new point, or access the Close Loop
screen to close the loop.
Overwrite : Allows you to overwrite the coordinates of
the benchmark with the new coordinates. This option
will not be available when the benchmark entered in the
Turn to Benchmark
screen was the same as the starting
benchmark.
Use Next : allows you to create a new point using the
coordinates entered in the Turn to Benchmark screen
and the elevation measured from the previous shots.
This option should not be selected when shooting the
closing benchmark.
Close Loop By Existing Point : opens the Close Loop
screen, described next.