Reference Manual Owner manual

Survey Pro Reference Manual
R-234
Prompt choose points Prompt geodetic points only
Adjust job with new projection: is where you choose to adjust the job
file points with the change of coordinate system.
Adjust Horizontal and/or Vertical: is where you choose how to update
the horizontal and vertical coordinates in the job. There are two
choices:
Adjust All Points: use this setting when you want to adjust all
points. The method used to adjust plane and geodetic points is
described on the Select Points page.
Adjust only points with geodetic coordinates: use this setting when
you want to update only geodetic points. The method used to adjust
geodetic points is described on the Select Points page.
Note: The display of these controls will vary depending on the
difference between the old and new coordinate system. First, if you
change the coordinate system in only one dimension, the display title
will indicate which dimension the setting is for. Second, depending
on how you change the coordinate system, the option to adjust all or
geodetic only may or may not be available. If the choice is not
available, you will see some text describing which points will be
adjusted. Third, if you change both dimensions, and only one