Reference Manual Owner manual

Survey Menu – GPS Module
R-229
Multiple Point Results
This screen displays the values to be used to create the new GPS
control points.
New GPS Control Points to be Created: For all of the selected
points, this list box shows the new NEE location, the existing LLH
location, and the existing NEE location.
Show Details : Shows the same details for the selected
point as the Single Point Results screen shows,
described above.
Re-Enter : Clears the control point source for the
selected point in the list box and returns to the previous
screen.
< Back : Returns to the selection screen.
Finish : See the section on Finish below.
Finish
The finish behavior will be one of three cases:
1. Create the control points, solve the localization with
all job file control points, launch the projection
readjust wizard and apply the updated localization to the map
projection zone.
2. Create the control points and open the solve localization wizard.
3. Create the GPS control points and exit the wizard.