Reference Manual Owner manual

Survey Pro Reference Manual
R-228
Single Point Results
This page displays the values to be used to create the new GPS
control point.
New GPS Control Point to be Created: This shows the new NEE
location for the selected point, the existing LLH location, the existing
NEE location, and the deltas between the new and old locations. This
will also include data sheet details if the control point source comes
from an NGS data sheet or an OPUS Solution Report
file.
Tap [Finish] to…: determines what will occur after
tapping Finish from the following options:
• Automatically solve localization / calibration
• Open the solve localization/calibration wizard
• Solve the localization/calibration later
< Back: This opens a prompt asking if you want to
reenter the control source for the selected point. If Yes,
the control point source is cleared for the point and the
previous screen is open. If No, we leave the control point
source and go back to the selection screen.
Finish : See the section on Finish below.