Reference Manual Owner manual

Survey Menu – GPS Module
R-179
Base Setup
Base Setup One – Pick Base Point
The first Base Setup screen is used to pick the base point and set the
antenna height.
Base Setup, standard Base Setup, one point setup
Base Point: is where you enter the point name that the base antenna
is set up over, or displays the name of the remote base point or the
name of the one job file point when using one point setup mode. You
can enter an existing point, or enter a new point name to start this
survey from a new autonomous base setup.
Note: When this screen is used in one point setup mode, the one job
file point is automatically used as the base point and you use this
screen to enter antenna height. When this screen is used to configure
base position in Survey Pro after remote base setup from the rover,
then this screen is used to display the base point name and antenna
height received from the data modem link.
Antenna: displays antenna setup for this receiver. It will be in one of
three states: