Reference Manual Owner manual

Survey Pro Reference Manual
R-170
Cell Modem
The Cell Modem card displays information about the radio
communications and allows you to disconnect or reconnect a cell
phone of IP modem connection.
Receiver mode: (see the Receiver Status
card, Page R-168.)
Modem Reception: displays two values indicating the
data modem signal quality. This information is only
displayed if the receiver is in rover mode.
Signal Latency: displays the age of the differential
correction used in the current GPS solution. This value
should be one second or less for good RTK solutions. If
this value is consistently greater than one second, check
the data modem link.
Reception: displays the receiver’s estimation of the
percent quality of the radio link.
Dial : Dials the cell phone or IP modem using the
configuration set in the Cell Phone Settings or IP Modem
Settings screen, respectively.
Hang up : Disconnects the cell phone or IP modem
connection.
Post Process
The Post Process card displays information about GPS
raw data logging for post processing.
Note: Some GPS receivers monitor post processing
session status while others simply record event markers
in the log file. If your receiver does not monitor sessions,
some fields are not displayed.
Status: displays information about the recording. It will
be one of four values
• No Communication: we are not receiving a
response to commands.