Reference Manual Owner manual

Survey Menu
R-135
Corner & Angle
Survey Corner & Angle.
The Corner and Angle screen is used to store a point that cannot be
shot on a reference line using a reflectorless total station where two
other points on the same line can be shot.
Foresight: is the name of the point that will be stored.
Description: is the description for the point that will be
stored.
HR: 0.000: shows that no rod height will be used with
this routine since all shots are direct reflectorless.
Shoot Line : will prompt you to take two shots on a line
that intersects with the point you want to store.
Note: Each shot can be in any location on the line. (Shot
1 can be to the left or right of Shot 2.)
Aim at Corner : will prompt you to aim at the corner (the
point that you want to store). Although no shot is taken,
the angles to the point will be used to compute its location.
Note: After all shots are done, the computed elevation is
displayed for the new point. You can either enter a different
elevation or tap to accept the computed elevation.
Backsight : accesses the Backsight Setup screen (Page R-
114) where the current backsight can be modified.
Line
Aim at target

(no shot)
Shot 1
Shot 2
Corner & Angle