Reference Manual Owner manual

Survey Pro Reference Manual
R-94
transfer GPS measurements in real time. This mode is used to
setup both static and stop/go post processing receivers.
• Ntrip Rover: Select this mode to use the receiver as an RTK rover
where the base corrections are to be supplied to the rover by
connection to an Ntrip service. To configure an Ntrip rover, you
must setup the Windows Networking modem parameters on the
Data Modem card.
Note: You do not need to select the RTK Correction Format for an
Ntrip rover because this will be determined by the Ntrip service you
pick at rover setup time.
Elevation Cutoff: is where you set the elevation cutoff for satellite
tracking. This value will be set in the receiver the next time you
configure it as a base, rover, or static receiver.
Data Modem Settings
The Data Modem card is used to view and configure the settings for
the modem used to transmit RTK base corrections or receiver RTK
rover corrections. The data modem card is not used when your
Receiver Mode is set to Post Processing.
Pac Crest or OEM Radio Cell Phone or IP Modem