Reference Manual Owner manual

Job Menu – GPS Module
R-93
Rx Settings
Job Settings Receiver Receiver Settings… Rx Settings or
Job Settings Receiver Create New Receiver… Rx Settings or
Connect to Receiver Receiver Settings Rx Settings or
Connect to Receiver Create New Receiver Rx Settings or
The Rx Settings screen contains three cards to configure the receiver
mode, RTK correction type, RTK data modem, satellite tracking
elevation cutoff, as well as some settings specific for particular brands
and models of receiver.
Receiver Settings
The Receiver card is used to set the mode of the receiver, the
correction format for RTK receivers, and the elevation cutoff for
satellite tracking.
Brand: displays the receiver manufacturer selected in
the Receiver Setup
screen.
Model: displays the receiver model selected in the
Receiver Setup screen.
RTK Correction Format: is where you set the format for
communication between the base and rover.
Receiver Mode: is where you set the mode of operation
of this receiver. There are four choices:
• RTK Base: use this mode to set the receiver as an
RTK base, which will broadcast GPS corrections in
the selected RTK Correction Format over the
transmitting data modem.
• RTK Rover: use this mode to set the receiver as an
RTK rover, which will listen for GPS corrections on
the receiving data modem, and calculate a differential GPS
position in real time.
• Post Processing: use this mode to set the receiver to collect GPS
raw data for post processing. No data modem will be used to