User Manual Manual

Trouble Shooting
85
• Stake out to Point
101
has now begun. Watch the design
location move to the rover location, as you get closer.
• Press to accept this staked location and return to the
Stake Points screen.
10. Conventional measurements
• Tap the instrument icon in the title bar and switch to
Conventional Mode
.
• Go to the Surveying
card from the Job, Settings screen.
Select
Use Scale Factor
and
Prompt to Reset Scale With New
Setups
. You need to apply a scale factor to your conventional
measurements because your coordinate system is a mapping
plane. ( If you were using localization, you will generally leave
scale factor for conventional measurements at 1.0.) Tap
to open the Scale Calculator
wizard.
11. Set up back sight.
• Go to Back Sight Setup
. Occupy
OIP1
, and back sight
OIP2
and tap .
• You are prompted that the scale factor for this point is
different from the current scale factor. Tap .
• Use the Scale Calculator
to solve the scale factor for this
setup. A new mode record is written to raw data.
12. Side shots and traverse.
• Take a 100.0-m . View the results tab to see how
the horizontal distances are scaled.
• Take a shot at
AR = 0.0
,
ZE = 45.0000
,
SD = 1000.0
.
At the prompt, tap .
• You will be prompted to reset scale since your elevation has
changed significantly.
• The scale is updated and a new mode record is written to the
raw data. Subsequent shots are scaled with the new value.
13. Using the scale factor in COGO calculations
• Go to Point in Direction
from the Cogo menu.