Reference Manual Instruction Manual

58
Using the Web Server
– Pin: 4- to 8-character pin code of the SIM card used in
the modem for GPRS operation.
– 2G Only: Recommended to save power.
• Set the following parameters in the Internal Modem/GPRS
Mode Settings pane (the mobile communication provider
you are using should be able to give you all this
information):
– Internet Protocol: Choose the Internet protocol (TCP or
UDP) allowing the modem to perform an Internet
connection.
– Access Point: Enter the URL of the mobile
communication provider.
– Access Point Login: Enter the login of the mobile
communication provider.
– Password: Enter the password of the mobile
communication provider.
• Click on the Configure button.
• Now please follow all the steps described in section
General Parameters on page 49 and then proceed with the
steps below.
• Still on the Rover Setup page, in the Network pane, set the
following parameters:
– Connection: Choose “Modem Ntrip Client - Port E”. As
a result, new fields appear in this pane that you should
set as instructed below:
– Connect Now: Enable this option to allow the receiver to
establish the connection right after you have clicked
on Configure.
– Address, Port, Login, Password: Enter the information
allowing the receiver to connect to the NTRIP caster.
This information should have been passed on to you
earlier by the administrator of this service.
– Load Source Table button: Click on this button after you
have entered the information about the NTRIP caster.
As a result, the list of available sources from this caster
appears just underneath. (See example below.)