Reference Manual Instruction Manual

Using the Web Server

authentication (e.g. SpiderNet). In that case, the

message “$GPUID,<login>,<password> will be

generated automatically and sent to the server when

clicking on Configure

Enable Connect Now to allow the receiver to establish

the connection right after you have clicked on

Configure.

• At the bottom of the page, in the Differential Port pane,

select the Automatic option to let the receiver detect the

incoming differential stream automatically.

NOTE: Automatic is the recommended choice for the

Differential Port setting because in this case, you don’t

need to define the ports receiving the two possible

differential streams.

• Click on the Configure button to let the Web Server load all

your new parameters to the receiver. You just have now to

define the output messages (see Defining Output

Messages on page 64).

NTRIP Client Via

Modem

The internal modem should be configured first:

• Click on the Connections menu and then on the Bluetooth/

Modem sub-menu.

• Set the following parameters in the Internal Modem/Device

Settings pane:

– Power: Select “On”. Then choose whether the modem

should be turned on automatically or manually:

Automatic: The modem will be switched on or off

automatically when the rover is respectively turned on

or off.

Manual: The modem will be powered up only by going

through the Connections > Bluetooth/Modem page and

setting the modem to “Power On” (or using the

$PASHS,MDM,ON command).

– Automatic Connection: Check this option.

Modem

RTK Corrections

ProFlex 800

NTRIP Caster

(Mobile Wireless

Communication)

Internet

IP address

or server name

(Client)