Reference Manual Instruction Manual

488
Set Command Library
UPL,UPG: Upgrading the Receiver Firmware from FTP
Function This command is used to download a firmware upgrade from
the FTP server declared with $PASHS,UPL,PAR, and then
perform the upgrade.
Command Format Syntax
$PASHS,UPL,UPG[,s1]*cc
Parameters
Example
Upgrading from file “p_800_upgrade_S607Gs23.tar.bz2”
found on the FTP server:
$PASHS,UPL,UPG,p_800_upgrade_S607Gs23.tar.bz2*0E
After successful completion of the file to the receiver, the
following response line is returned:
$PASHR,UPL,UPL,REBOOT,p_800_upgrade_S607Gs23.tar.bz2*29
Then, communication with the receiver is suspended until
upgrade installation is complete.
Should the file transfer fail, the following response line will
appear:
$PASHR,UPL,FAIL,p_800_upgrade_S607Gs23.tar.bz2*42
Relevant Query
Command
$PASHQ,UPL
See Also $PASHS,UPL,PAR
Parameter Description Range
s1
Name of the upgrade file that will be first down-
loaded to the receiver and then used to perform
the firmware upgrade.
• The file name can contain a relative path to the
path defined BY $PASHS,UPL,PAR.
• If s1 is missing or only consists of a path, then
“p_800_upgrade_********.tar.bz2 is down-
loaded, provided there is only one of these files
available on the FTP server, otherwise the com-
mand will be NAKed.
255 characters
max.
*cc Optional checksum *00-*FF