Reference Manual Instruction Manual

479

Set Command Library

TCP,PAR: TCP/IP Server Settings

Function This command is used to set the TCP/IP server.

Command Format Syntax

$PASHS,TCP,PAR[,MOD,s1][,LGN,s2][,PWD,s3][,PRT,d4][*cc]

Parameters

Example

Enabling TCP/IP connection with authentication (login:

BX312, password: xwsead):

$PASHS,TCP,PAR,MOD,1,LGN,BX312,PWD,xwsead*1A

Comments • When the TCP/IP server is enabled (s1=1 or 2) and the

receiver is connected to a network via the Ethernet cable,

an external device can open the port specified as d4 and

communicate with the receiver. In this case, the current

port is port “I” in the receiver.

• When s1=1, the receiver does not accept any incoming

data or commands until it receives the login and the

password (see $PASHS,TCP,UID). It will however output

those messages that are programmed on port “I” even if it

has not received authentication yet.

• The default login is “ashtech” and the default password is

“password”.

• Both login and password are case sensitive.

Relevant Query

Command

$PASHQ,TCP