Reference Manual Instruction Manual

411
Set Command Library
If the receiver fails to download the source table, the
following response line will be returned:
$PASHR,NTR,FAIL*12
Relevant Query
Command
None.
See also $PASHQ,NTR,TBL
$PASHS,NTR,PAR
NTR,MTP: Connecting Receiver to NTRIP Caster Mount Point
Function This command allows you to connect the receiver to a NTRIP
caster mount point.
Command Format Syntax
$PASHS,NTR,MTP,s1[,c2][*cc]
Parameters
Example
Connecting to mount point MUWF0:
$PASHS,NTR,MTP,MUWF0*4D
If the connection is successful, the following response line
will be returned:
$PASHR,NTR,OK*cc
If the connection failed, the following response line will be
returned:
Parameter Description Range
s1
Name of the NTRIP mount point, or OFF command
(ending the connection to the current mount point).
100 characters
max., or OFF
c2
Internet port used to connect to the caster:
• E: Internal modem
• P: Ethernet stream 1
• Q: Ethernet stream 2
If c2 is omitted, the port used is the port defined
through the last $PASHS,NTR,PAR command run.
E, P, Q
*cc Optional checksum *00-*FF