Reference Manual Instruction Manual

369
Set Command Library
connection. The different connection modes available are
described below.
Connection Modes Server Mode: When a receiver is used in this mode, one or
more rovers can connect to it through a specific IP address
and port number to acquire the data stream it generates on
the specified Ix port.
Client Mode: When a receiver is used in this mode, it can
connect to an external server through a specific IP address
and port number for sending to this server the data stream it
generates on the specified Ix port.
Command Format Syntax
Disabling a data stream on a given Ix port:
$PASHS,DST,s1,OFF[*cc]
Setting a data stream with the receiver used in server mode:
$PASHS,DST,s1,ON,1,d4,d5[*cc]
Setting a data stream with the receiver used in client mode:
$PASHS,DST,s1,ON,2,d4,d5,s6[*cc]
Parameters
Examples
Disabling data stream on port I3:
Parameter Description Range Default
s1 Data stream port I1-I9
s2 Enable/disable control parameter ON, OFF OFF
d3
Connection Modes:
•1: Server
• 2: Client
1-2 1
d4
IP mode:
•0: TCP
• 1: UDP
0, 1 0
d5
IP port number:
• If d3=1 (Server), specify the number of the
receiver’s internal port used.
• If d3=2 (Client), specify the number of the
external server’s IP port used.
100-
65535
1000-
1009
s6
IP address or host name:
• If d3=2 (Client), specify the external server’s
IP address.
32 char
max.
0.0.0.0.
0
*cc Optional checksum *00-*FF