Reference Manual Instruction Manual

366
Set Command Library
Parameters
Comments
When connecting to the specified server requires a user name
and password, then the receiver will send the serial command
$GPUID,s3,s4 after the IP connection with the server has
been established.
Examples
Entering the parameters of the server the receiver has to
connect to (through an IP address):
$PASHS,DIP,PAR,ADD,192.65.54.1,PRT,2100*74
Entering the parameters of the server the receiver has to
connect to (through a host name):
$PASHS,DIP,PAR,ADD,www.MyRec.com,PRT,2100*05
Relevant Query
Commands
$PASHQ,DIP
$PASHQ,MDM
$PASHQ,ETH
See Also $PASHS,DIP,ON
$PASHS,DIP,OFF
$PASHS,MDM
$PASHS,ETH,..
Parameter Description Range Default
ADD,s1
IP address or host name of
external server
32 characters max.
PRT,d2 IP port of external server 0-65535
LGN,s3 User name (optional) 32 characters max.
PWD,s4 Password (optional) 32 characters max.
IPP,c5
Port used in the receiver to
establish the IP connection:
• E: Internal modem
• P: Ethernet stream 1
• Q: Ethernet stream 2
E, P, Q E
*cc Optional checksum *00-*FF