Reference Manual Instruction Manual

354
Set Command Library
CST,ON: Starting the Embedded NTRIP Caster
Function This command is used to launch the embedded NTRIP caster
in the receiver. By default, the embedded NTRIP caster is off.
Command Format Syntax
$PASHS,CST,ON[*cc]
Parameters
None.
Example
Starting the embedded NTRIP caster:
$PASHS,CST,ON*1C
Relevant Query
Command
$PASHQ,CST
See Also $PASHS,CST,OFF
$PASHS,CST,PAR
CST,PAR: Embedded NTRIP Caster Parameters
Function This command is used to define the parameters of the
embedded NTRIP caster. All these parameters will appear in
the NTRIP caster source table.
Warning! Make sure the command does not exceed 349
characters in length before sending it to the receiver.
Command Format Syntax
$PASHS,CST,PAR,d1,s2,s3,d4,s5,s6,s7,f8,f9,s10,d11,s12,s13,c14[,s15,
s16,s17][*cc]
Parameters
Parameter Description Range Default
d1 IP port number of the NTRIP caster 100-65535 2101