Reference Manual Instruction Manual

328

Set Command Library

$PASHS,BDS,RT2,I1,OFF*OF

Relevant Query

Command

$PASHQ,BDS

See Also $PASHS,DST

$PASHS,RTC,TYP

$PASHS,ATD,TYP

BEEP: Beeper Setup

Function This command enables or disables the internal beeper.

Command Format Syntax

$PASHS,BEEP,s1[,d2][*cc]

Parameters

Example

Disabling the beeper:

$PASHS,BEEP,OFF*04

Relevant Query

Command

$PASHQ,BEEP

BRD: Enabling/Disabling the RTC Bridge Function

Function This command is used to control the RTC Bridge function. Its

use is required only in the receiver in charge of forwarding its

Parameter Description Range Default

s1 Enables (ON) or disables (OFF) the beeper. ON, OFF ON

Timeout, in seconds:

• 0: No timeout. If an alarm is activated, the

beeper will sound indefinitely until the

alarm is acknowledged.

• >0: If an alarm is activated, the beeper

will sound only for a limited period of time

(it will go out automatically at the end of

the specified timeout).

0-99 30

*cc Optional checksum *00-*FF