Reference Manual Instruction Manual

319

Set Command Library

Parameters

Examples

Entering the vertical measurement (2 m) of a rover antenna:

$PASHS,ANT,0,0,2.000*2E

Entering the slant measurement (1.543 m) of the

MAG111406 antenna used at a base:

$PASHS,ANT,1.543,0.0921,-0.0516*0A

Comments • The vertical height from ARP to ground mark can also be

entered through the ANT command, which in this case

should be used as follows:

– Set f1 and f2 to “0.0”

– Enter the antenna height from ARP to ground mark as

f3. Only when f1=f2=0.0 can you define f3 this way.

– f3 is negative when the ARP is below the SHMP.

• When you enter an antenna height greater than 6.553 m

(see f1 and f2 above), be aware this will NOT be the value

of antenna height broadcast through RTCM messages and

the one saved to the G-file. Instead, a fixed value of 6.553

meters will be provided.

Relevant Query

Command

$PASHQ,ANT