Reference Manual Instruction Manual

318

Set Command Library

$PASHS,ANT

ANT: Antenna Height

Function This command is used to define the antenna height,

especially when it was determined using the slant

measurement method. However, a vertical measurement can

also be entered through this command.

Using the $PASHS,ANT command overwrites all previous

settings performed with the $PASHS,ANH command.

Command Format Syntax

$PASHS,ANT,f1,f2,f3[*cc]

Diagrams and Definitions

• ARP: Antenna Reference Point (usually bottom of the

antenna).

• SHMP: Slant Height Measurement Point (usually at the

hedge of the antenna, above the ARP).

• Ground Mark (GM): above the ARP (same horizontal

coordinates).

Slant Measurement Vertical Measurement

ARP

SHMP

GM GM