Reference Manual Instruction Manual

316
Set Command Library
Relevant Query
Command
$PASHQ,ANP
See also $PASHS,ANP,DEL
ANP,REF: Naming the Antenna Used at the Base
Function This command is used to enter the name of the antenna used
by the base with which the receiver is working.
Command Format Syntax
$PASHS,ANP,REF,s1[,d2][*cc]
Parameters
Comments
• Specifying the antenna name allows the receiver to know
the antenna offset parameters using the predefined list. In
the receiver, the predefined parameters can be listed
using $PASHQ,ANP. New offset parameters can be added
using $PASHS,ANP,PCO.
• The predefined list complies with the IGS antenna source
table.
Example
Entering “MAG990596” as the name of the base antenna:
$PASHS,ANP,REF,MAG990596*3A
Relevant Query
Command
$PASHQ,ANP
$PASHQ,ANP,REF
Parameter Description Range Default
s1
User-defined antenna name (case-
sensitive).
31 characters
max.
UNKNOWN
d2
Antenna name preference:
• 0: s1 is ignored if a base
antenna name is decoded from
the incoming reference data.
• 1: s1 is always used regardless
of whether a base antenna
name is decoded from the
incoming reference data or not.
0, 1 0
*cc Optional checksum *00-*FF