Reference Manual Instruction Manual

302
Using Serial Commands
UHF Radios
Modem
$PASHS,CP2,RST Reset second RTK process
$PASHS,CPD,VRS VRS assumption mode $PASHQ,CPD,VRS VRS assumption mode
$PASHS,DYN Receiver dynamics $PASHQ,DYN Receiver dynamics
$PASHS,LCS
Enable/disable use of local
coordinate system
$PASHQ,LCS Local coordinate system status
$PASHS,LTZ Local time zone $PASHQ,LTZ Local time zone
$PASHS,PEM Position elevation mask $PASHQ,PEM Position elevation mask
$PASHS,PHE Event marker active edge $PASHQ,PHE Event marker active edge
$PASHS,PPS PPS settings $PASHQ,PPS PPS settings
$PASHQ,RCP Receiver parameters
$PASHS,RCP,DEL
Deleting user-defined receiver
name
$PASHS,RCP,GBx
Defining GLONASS biases for
user-defined receiver
$PASHQ,RCP,OWN Receiver name
$PASHS,RCP,REF Naming reference receiver $PASHQ,RCP,REF Reference receiver name
$PASHS,SNM Signal-To-Noise Ratio Mask $PASHQ,SNM Signal-To-Noise Ratio Mask
$PASHS,SVM Satellite use mask $PASHQ,SVM Satellite use mask
$PASHS,UDP User-defined dynamic model $PASHQ,UDP User-defined dynamic model
$PASHS,UTS Synchronization with GPS
$PASHQ,UTS Synchronization with GPS
$PASHS,VCT Type of vector coordinates
$PASHQ,VCT Type of vector coordinates
$PASHS,VEC Vector output mode
$PASHQ,VEC Vector output mode
$PASHS,ZDA Set time and date
Set Command Description Query Command Description
Set Command Description Query Command Description
$PASHS,RDP,OFF Powering off internal radio
$PASHS,RDP,ON Powering on internal radio
$PASHQ,RDP,CHT Radio channel table
$PASHQ,RDP,LVL Radio reception level
$PASHS,RDP,PAR Setting the radio $PASHQ,RDP,PAR Radio parameters
$PASHQ,RDP,PWR Radio Type and Radiated Power
$PASHS,RDP,TYP Radio type used $PASHQ,RDP,TYP Radio type used
Set Command Description Query Command Description
$PASHQ,MDM Modem status and parameters
$PASHS,MDM,INI Initializing the modem
$PASHQ,MDM,LVL Modem signal level
$PASHS,MDM,OFF Internal modem power off
$PASHS,MDM,ON Internal modem power on
$PASHS,MDM,PAR Setting modem parameters
$PASHQ,MDM,STS Modem status
$PASHS,MWD Modem timeout $PASHQ,MWD Modem timeout