Reference Manual Instruction Manual

125
Web Server Help Files Collection
Configuration Tab
Making Changes to
a Receiver
Configuration
Please read below the general instructions and notes about
the Configuration tab:
• Clicking on the Configuration tab causes the connected
receiver to display its current settings.
• You may have to wait a few seconds before the receiver
can respond.
• The content of the Configuration tab is read once on
opening each page.
• Whenever you change one or more receiver parameters in
a page, you need to click on the Configure button located
at the bottom of the screen to let the Web Server upload
the new parameters to the receiver.
When you click on the Configure button, a routine is run to
check the validity of the new parameters and a new page
opens in the Web Server. If the new parameters are valid,
the message Successful is displayed after all the new
parameters have effectively been uploaded to the receiver.
If some of them are not valid, the message Failed is
displayed, followed by the list of invalid parameters. You
then need to return to the relevant Configuration page,
correct the erroneous parameters and resume the
Configuration operation.
Note that in the receiver, any attempt to replace a
parameter (hence a valid one) with a new parameter that
is invalid will always abort (i.e. the receiver will keep the
valid parameter in its memory).
• In each of the tables presented hereafter to describe the
receiver configuration parameters, the third column
provides for reference the relevant $PASHS command,
that is the set command you could alternatively use to set
or change the described parameters.
Stack IP Modem Stack IP firmware version VERSION
Internal Radio Internal radio firmware version VERSION
Can Controller Can Controller firmware version VERSION
Web Interface Web Interface firmware version VERSION
NTRIP Caster NTRIP caster firmware version VERSION
Parameter Designation $PASHQ