Product Manual

29
Wall Mount
1. Nail Holes (3) – allows you to hang the wall mount onto nails or screws.
2. Locking Screws – lock/unlock the wall mount at the wall molding or floor
track.
3. Locking Knob—tightens/loosens the sliding bracket in place after it
has been positioned along the elevation scale.
4. 5/8“ –11 Laser Mount – lets you connect the laser to the wall mount.
5. Fine height adjustment screw—lets you fine adjust the laser’s position
on the wall mount.
6. Adjustment screw – adjust the slider‘s movement tightness considering
the laser weigth.
7. Elevation Scale – provides graduated marks that indicate the position
of the laser relative to the wall molding height. The adjustment range
on the scale is from 3.1 cm (1 1/4 in.) above wall-molding height to
5 cm (2 in.) below it.
(The “–2“ position is aligned with the horizontal centerline at the
ceiling target.)
8. Reading Edge – allows you to adjust the laser position appropriate for
your application needs.
9. Vertical-Alignment Notch—shows the position of the laser beam when
the laser is set up in vertical mode and is moved up to the
top (3.1 cm [1 1/4 in.]) stop.
Note: The laser handle should be used as a safety hole —provide a
place to tie a safety wire when mounted to a wall.