Product Manual

12 GL700 Series Laser Transmitter Quick Reference Guide
1. Remove the four screws from the battery housing.
Remove the battery housing compartment.
2. Install/remove the batteries.
Note – when installing the batteries, be sure to
note the positive (+) and negative (–) diagram
inside of the housing.
Note – The laser has reverse voltage polarity
protection. If the batteries are put in wrong, no
damage occurs to the laser but it does not work.
Allow one minute for the laser to recover after the
batteries have been installed correctly.
3. Put the battery-housing compartment in place and reinstall the four screws.
To let you know when the batteries are getting low, the status LED flashes. When
the status LED flashes yellow, the laser has less than one hour of running time.
When the status LED remains on solid yellow, the batteries have less than five
minutes running time.