Product Manual

15
IfnotalreadysettoLS,pressUnitsbuttonandthenpressDeadbandorAudiobuttonuntilLS is displayed.
PressUnitsbuttonagaintoenterselection.PressandreleasetheAudiobutton–displayshowsPAIR.Press
theUnitsbuttonagain–thedisplayshowsPAIRandarotatingbar.AftercompletingPAIR,OKwillbedisplayed.
TheGL6X2Npairsnowautomaticallywiththenewreceiver.PressandreleasethePowerbuttontwotimesto
exitthemenu.Alasersymbolislittoconrmthereceivercancommunicatewiththelaser.
8.4 Pairing the laser with the signal transporter (ST802/ST805)
MakesuretheST802/ST805isswitchedoff.StartwiththeLaser.WheninmenuSettings(Pic35),pressand
release button 4 to open the pairing menu (Pic 47). The display shows the currently paired units (one signal
transportermax).MakesuretheSTslotisfreeforthesignaltransportertobepaired.Iftheslotisnotfree,
choosetheSTslotanddeleteitusingbutton1(CLR).Pressbutton2tostartthepairingprocess.Switchon
thesignaltransporter.Thesignaltransporterpairsautomaticallywiththelaser.Ifthepairingwassuccessful
theaddressorIDofthepairedSTisshowninthepairinglist;alsothesignaltransportershowsasolidblinking
yellowstatusLED.
8.5 Grade Entry
SelecttheGradeEntryicon(Pic48)andpressandreleasebutton4toopentheGradeEntrymenu.
Buttons6/7canbeusedtotogglebetweenStepandGo(Pic49)andDigitSelect(Pic50).
Press and release button 4toconrmtheselection.
Pic 49
Step and Go
Pic 50
Digit Select
8.6 Grade Display
SelecttheGradeDisplayicon(Pic52)andpressandreleasebutton4toopentheGradeDisplay
menu.
ThedesiredGradeDisplayMode(Percent(Pic52)/Permille(Pic53)/Degree(Pic54))canbe
selected using the buttons 6/7. Press and release button 4toconrmtheselecteddisplaymode.
8.7 Sensitivity Selection
Select the Sensitivity icon and press and release button 4toopentheSensitivitymenu(Pic56).
ThedesiredSensitivity:Low(Pic56),Mid(Pic57)(Default)andHigh(Pic58))canbeselected
using the buttons 6/7. Press and release button 4toconrmtheselectedSensitivity.
Pic48
GradeEntry
Pic52
GradeDisplay
Pic53
Per mill
Pic52
Percent
Pic54
Degree
Pic56
Sensitivity
Pic56Low
Pic57Mid
Pic58High