Product Manual

Unit Setup

1. Install the battery

The Lithium-Ion (Li-Ion) battery and

battery cover are shipped detached from the

unit. Insert the battery into the compartment

so the connectors on the battery mate with

the pins in the battery compartment. Press

firmly. Place the battery door over the

battery, with the flat side of the battery door

at the top.

Remove the rubber cap from the end of the

stylus to expose a Philips screwdriver, or

use a small #1 Philips head screwdriver to

finger-tighten the four screws in the battery

door.

NOTE: DO NOT use the screwdriver part of the stylus on

the touchscreen or it will scratch your screen. Only use the

spring-tip end of the stylus.

2. Charge the battery

The power supply that ships with your unit has four international

plugs that fit almost every electrical outlet in the world. Connect the

appropriate plug to the power cord and attach the power supply.

Plug into an electrical outlet and plug the barrel end of the power

supply into the unit.

Warning! Be sure to only use the power supply

included with your unit. Use of other adapters

may void the product warranty.

3. Attach the hand strap

Attach the hand strap to the back case, as shown.

IMPORTANT: Fully charge the battery once it’s installed in the

unit. The battery gauge may not be accurate until it has been

fully charged at least one time, which should take

approximately 4 ½ hours. The battery LED (right side of unit)

will turn green once it’s fully charged.