Product Manual

43
Advanced GPS Page
Return to Default Settings:
When connected to your Nomad GPS
receiver: Tapping the Return to Default
Settings button, the following settings
are changed and applied to your Nomad
GPS receiver:
 Resets NMEA strings to defaults of:
o GGA – 1 sec
o GSA – 1 sec
o GLL – off
o VTG – off
o GSV – 1 sec
o RMC – off
NOTE: The COM settings are grayed out and cannot be changed until
you disconnect from your Nomad GPS receiver.
When disconnected from your Nomad GPS receiver: Tapping the
Return to Default Settings button, the following settings are changed:
 Resets NMEA strings to defaults of:
o GGA – 1 sec
o GSA – 1 sec
o GLL – off
o VTG – off
o GSV – 1 sec
o RMC – off
NMEA message settings (set to default or otherwise) will be sent to your
Nomad GPS receiver and applied the next time you connect to your
Nomad GPS receiver (with output set to NMEA).
 If the Microsoft GPS driver is not used, the COM port gets set to
COM2.
 If the Microsoft GPS driver is used, the COM port gets changed
to its assigned program port.
 Sets baud rate to 9600
 Data bits are set to 8
 Flow is set to None
 Parity is set to None
 Stop bit is set to 1
Since you are not connected to your Nomad GPS receiver, none of the
changes are actually applied to your Nomad GPS receiver.