Product Manual

39
Restore Defaults:
When connected to your Nomad GPS receiver: Tapping the Restore
Defaults tab will result in the following settings being changed:
 GPS receiver output will be set to NMEA mode
 Static Navigation will be turned OFF
 Smooth Tracking will be turned OFF
 Elevation mask is set to five
 PDOP mask is set to eight
 HDOP mask is set to eight
 GPS status voice prompt is turned OFF
 NMEA message settings under the Advanced page are
changed as follows:
o GGA – 1 sec
o GSA – 1 sec
o GLL – off
o VTG – off
o GSV – 1 sec
o RMC – off
 DGPS settings under the DGPS tab are set back to their defaults
of Usage: Auto, Type: SBAS ON and SBAS Sat. PRN: Auto
 No change to any COM settings
Each of the above settings (except for the GPS status voice
prompt) are sent and applied to your Nomad GPS receiver.
When disconnected from your Nomad GPS receiver: Tapping the
Restore Defaults tab will result in the following settings:
 GPS receiver output will be set to NMEA mode
 Static Navigation will be turned OFF
 Smooth Tracking will be turned OFF
 Elevation mask is set to five
 PDOP mask is set to eight
 HDOP mask is set to eight
 GPS status voice prompt is turned OFF
 NMEA message settings under the Advanced page are changed
as follows:
o GGA – 1 sec