- Northern Airborne Tec usr guide control head TAC/COM SERIES

SM06 Rev. 4.10 Tac/Com Control Head Manual
Jan 4, 2006 Page iv
ENG-FORM: 820-0110.DOT
CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.
Section Title Page
2.5 Troubleshooting 2-6
2.5.1 Weak Receive/Transmit, Intermittent Operation, Erratic Squelch 2-6
2.5.2 Strange Noises, No Receive Audio, Transmit Keying problems 2-6
2.5.3 Some Frequencies Can't be Edited 2-6
2.5.4 Display Brightness is Too Low, Can't Increase to Full Brightness 2-6
2.5.5 Amber (RX) Squelch light comes on, but no RX audio is heard. 2-7
2.6 Final Inspection 2-7
2.7 Continued Airworthiness 2-7
2.8 Installation Drawings 2-8
2.8.1 Outline drawings 2-8
2.8.2 System Connector (J-100) 2-8
3 Operation
3.1 Introduction 3-1
3.2 General 3-1
3.3 Initial Operation 3-2
3.3.1 Power-up Help 3-2
3.3.2 Initial Operating Display 3--2
3.4 Front Panel Controls 3-3
3.4.1 Radio Specific Controls 3-4
3.4.2 General Controls - NORMAL Operation 3-6
3.5 Editing 3-10
3.5.1 Channel Editing 3-11
3.5.2 Summary of Channel Editing 3-14
3.5.3 Summary of Channel Labels 3-15
3.5.4 Summary of Subaudible Tones 3-16
3.6 Status Line Editing 3-19
3.6.1 NEXT and SELECT Switch Use 3-20
3.6.2 Status Edit Features 3-21
3.7 Channel Display Summary 3-23
3.7.1 Display Switch Set to 'ID' 3-23
3.7.2 Display Switch Set to 'RX' 3-24
3.7.3 Display Switch Set to 'TX' 3-24
3.8 Changing Display Brightness 3-25
3.9 Scanning 3-25
3.9.1 Scan Modes 3-27
3.10 NAT NTX138 Wide-band/Narrow-band Operation 3-28
3.11 Master Edit Mode 3-29
3.11.1 Entering Master Edit Mode 3-29
3.11.2 How Data is Stored in the Control Head 3-30
3.11.3 Editing Considerations 3-30
3.12 Installation & Configuration Mode 3-31
3.12.1 Entering Configuration Mode 3-31
3.12.2 Configuration Option Table 3-32